Rico Cannelure profile


The plinth for the factory coating on the wall. It's a plastic strap in the shape of a rounded trapezoid, installed directly under the linoleum in the junction of floor and walls. With it, linoleum smoothly get on a wall, thus forming the skirting board of the same linoleum. The fillet between the floor and the wall prevents accumulation of dirt and dust. It makes cleaning more easier.

This type of skirting board is widely used in medical institutions and areas where there are high demands on purity.

Standard color: grey.

Company ROSMAT Ltd are able to produce moldings of any color to your order. For more detailed information, check with the managers of the sales Department.

Advantages:
  • Soft edges at the hem allow the profile to fit snugly to the plane of the wall, prevent the penetration of dust and moisture.
  • Facilitates cleaning and disinfection of the premises.
  • Absolutely safe for health, eco-friendly, lead free.
  • Resistant to mechanical stress.
  • 100% moisture resistance.
  • You have the possibility to adjust the height of factory coating on the wall.
  • Simple and safe installation.

Installation of Rico Cannelure profile


Step 1: Make tick marks on the walls with a pencil around the perimeter of the room. Point out the height of linoleum that You want. At this height from the floor You must glue the strap.

Step 2: Above the aforementioned serif You need to stick mounting tape to prevent the glue ingress on clean surface.

Step 3: Apply glue full height, from the floor to the mark. Also apply glue to the floor along the wall on the perimeter of the room, the width of the applied adhesive strip on the floor should be approximately 40-50 mm. The floor and walls must be dry and free from dust, in accordance with the instructions for use of glue.

Step 4: Apply glue to the back side of the profile. After that, focusing on the tags You need to glue strap to the wall on the perimeter of the room. Joints edge profile in the corners of the room are cut at 45 degrees using a miter box and a saw with a fine tooth.

Step 5: At finish you should only glue cannelures profile around the perimeter of the room in place of junction walls and floor. Joints of cannelures profile in the corners of the room are cut at 45 degrees using a miter box and a saw with a fine tooth.


Edge colors

Grey (RAL1014)

Brown (RAL1011)

Green (RAL6011)

Beige (RAL6017)

Specification of Rico Cannelure profile

Name Pieces per Package Package dimensions Weight
Rico Cannelure profile 3,0 m 15 3020х85х140 mm 13,1 kg
gross